MIMAKI TS34-1800A - Page 39

Setting a Media
2-11
1
2
Basic Operations
4
5
6
11
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
12
Set an empty core of the roll media on the
take-up device.
13
Adjust the level adjuster attached to the left
take-up device.
(1) Loosen the screw of the level adjuster and move it
downward until it hits the floor.
(2) Tighten the screw to fix.
• Do not set media at the position which the media press touches the side plate on the right. As media
may tilt and be lifted, it could break the head.
• If a media is misaligned to the right more than fixed position, a
warning is displayed. Set the media again.
Media press
***** ERROR 50 *****
MED I A SE T POS I T I ON
Media press position : 8 to 18 mm from the side plate on the right.
(For the variation of the inside diameter of media roll, it ranges as above.)
Media
Media Press
Side plate of
the right
Core
Take-up
device
Level adjuster