MIMAKI TS34-1800A - Page 40

2-12
14
Close the front cover.
15
Press the key to select “ROLL” .
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance function is “ON”
( P.4-24), the screen for entering media remaining amount is
displayed after detecting the media width.
16
Secure the media on the take-up device.
(P.2-13)
(1) Feed the media up to the core of the roll media of the
take-up device by pressing the key.
(2) Fix the middle of the media with adhesive tape.
(3) In the same manner, fix the left side and right side of
the media.
• Make sure that the there is no slack or wrinkle on the
media in such condition that the roll media is pulled to
right and left evenly, and then stick the tape.
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is “ON” ( P.4-24), the screen for entering media
remaining amount is displayed after detecting the media width.
1
Display the screen for entering media remaining
amount.
2
Press to enter the media remaining amount.
3
Press the key.
Front cover
MED I A SE L EC T
ROL L < > L EAF
I npu t o f Med i aLeng t h
MED I A L ENGTH = x x x . x m
I npu t o f Med i aLeng t h
MED I A L ENGTH = 5 0 . 0 m