25
Operation
2. Apply AC line voltage.
3. Slowly advance the speed adjust potentiometer clockwise (CW). The motor slowly
accelerates as the potentiometer is turned CW. Continue until the desired speed is
reached.
4. Remove AC line voltage to coast the motor to a stop.
Speed adjust potentiometer input with START/STOP pushbuttons:
1. Turn the speed adjust potentiometer full counterclockwise
(CCW).
2. Apply AC line voltage.
3. Press the START pushbutton.
4. Slowly advance the speed adjust potentiometer clockwise (CW). The motor accel-
erates as the potentiometer is turned clockwise. Continue until desired speed is
reached.
5. Press STOP pushbutton to coast motor to a stop.
Analog signal input, no START/STOP pushbuttons:
It is necessary to wire a jumper between B1 and B3 if no START/STOP switches are
to be used.
1. Set the analog signal so that it is at its lowest level
(0V or 4mA).
2. Apply AC line voltage.
3. Slowly increase the analog signal. The motor accelerates as the signal is increased.
Continue increasing signal until desired speed is reached.
4. Remove AC line voltage to coast the motor to a stop.
To Next Page
Loading...
Need help?
General
