Minarik MM300 Series User Manual

39
Calibration
ACCELERATION (ACCEL)
The ACCEL setting determines the time the motor takes to ramp to a higher speed,
within the limits of available torque. The ACCEL setting is factory set for its fastest
acceleration time (full CCW).
To calibrate ACCEL:
1. Set the speed adjust potentiometer or input signal for minimum speed. The motor
should run at minimum speed.
2. Set the speed adjust potentiometer or input signal to maximum speed, and meas-
ure the time it takes the motor to go from minimum to maximum speed.
3. If the time measured in step 2 is not the desired acceleration time, turn the ACCEL
trimpot CW for a slower acceleration time, or CCW for a faster acceleration time.
Repeat steps 1 through 3 until the acceleration time is correct.
DECELERATION (DECEL)
The DECEL setting determines the time the motor takes to ramp to lower speed, with-
in the limits of available torque. The DECEL setting is factory set for its fastest decel-
eration time (full CCW).

Minarik MM300 Series Specifications

General

Brand	Minarik
Model	MM300 Series
Category	Controller
Language	English