24
5-3-1-2 Configure Bluetooth SPP profile communication
Note : Make sure the Bluetooth module of the terminal is powered on (blue LED is on) and the selected
profile is SPP.
Step 1: Press Left Soft Key to the SPP List, if no connection record, press Left Soft Key to search. Wait
for about 20 seconds and then the devices list will be shown
Step 2: Use Navigation Key to move the cursor and press Scan/Select Key to connect. The Bluetooth
device connected to the terminal is labeled √. And then you can press Right Soft Key to disconnect.
5-3-1-3 Configure Bluetooth BLE Slave profile communication
Note: Make sure the Bluetooth module of the terminal is powered on (blue LED is on), and the selected
profile is System SettingBluetoothBLE.
Step 1: Connect to Bluetooth 4.0 device and transmit data in low power mode.
5-3-1-4 Configure Bluetooth Cradle
Note1: Cradle is provided by the manufacturer to support reliable wireless data transmission, and it is
advised in applications whereas unacknowledged communication is unacceptable.
Note2: Make sure the Bluetooth module of the terminal is powered on (blue LED is on).
Note3: The default cradle transmission interface is a USB HID keyboard, and the optional interface is a
USB virtual serial port.
Note4: If you choose USB HID keyboard mode, can set the keyboard layout (default US keyboard),
transmission speed, number keys.
There are two methods to setup the Bluetooth communication.
Method I: scanning special barcode.
Step 1: Scan the barcode on the back of Cradle. The terminal will beep twice to indicate a successful
scanning
Step 2: Connect Cradle to a PC within 10 seconds. Then wait for about 5 seconds. The terminal will give
2 long beeps upon a successful connection, or 3 short beeps upon a failed connection.
Method II: operating the terminal on the OLED screen.
Step1. Press Left Soft Key towards the window below. If the terminal has no connection record, it will
show the indication of “There is no connection record.”
Step2. Press Search to the window below for searching.
Step3. Wait for about 20 seconds and then Cradle list will be shown.
Step4. Use Navigation Key to move the cursor and press Scan/Select Key to connect with Cradle.
Step5. Wait for about 3 seconds, the terminal will respond with 2 long beeps upon successful
connection.
Step6. The Cradle connected to the terminal is labeled √.
Step7. If you want to disconnect the cradle connected successfully before, you can press Scan/Select
To Next Page
Loading...
