Mindray BeneVision N17 - Hardware Configuration Options; Overview; Optional Parameter Function Modules; Optional Functional Assemblies

BeneVision N17/BeneVision N15/BeneVision N12 Patient Monitor Service Manual 5-1
5 Hardware Configuration Options
5.1 Overview
This monitor supports optional monitoring parameter function modules, optional functional assemblies,
and network upgrade of software.
NOTE
 For function upgrade involving disassembly of the monitor, eliminate static electricity before
the disassembly. When removing some parts with the electrostatic sensitive mark, wear
protective devices such as electrostatic ring or anti-electrostatic gloves, lest the parts would be
damaged.
 Properly connect and route the cables and wires when reassembling the equipment to avoid
pinched hoses and electrical short circuits.
 Use specified screws to reassemble the equipment. If the incorrect screws are forcefully
tightened, the equipment may be damaged and the screws or part may fall off during use,
causing unpredictable equipment damage or human injury.
 Be sure to follow the correct sequence when disassembling the monitor.
 Before removing assemblies, make sure that all the connection lines have been unplugged.
During removal, note to avoid breaking the connection line by pulling or damaging the
connector.
 Place the removed screws and other parts separately by category so that they can be used in
the re-installation. Do not drop, contaminate or lose them.