1-4 Safety Precautions
DO NOT allow the patient to contact the live parts of the
ultrasound system or other devices, e.g. signal I / O
ports. Electric shock may occur.
DO NOT touch the Signal I/O ports if in contact with the
patient; otherwise patient injury may result.
Do not use an aftermarket probe other than those
specified by Mindray. The probes may damage the
system causing a profound failure, e.g. a fire in the worst
case.
Do not subject the transducers to knocks or drops. Use
of a defective transducer may cause an electric shock.
Do not open the covers and front panel of the system.
Short circuit or electric shock may result when the
system hardware is exposed and powered on.
Do not use this system when any digital device such as a
high-frequency electrotome, high-frequency therapeutic
device or defibrillator is applied already. Otherwise, there
is a risk of electric shock to the patient.
When moving the system, you should first fold the
keyboard, disconnect the system from other devices
(including probes) and disconnect the system from the
power supply.
Accessory equipment connected to the analog and digital
interfaces must comply with the relevant IEC standards
(e.g., IEC 60950 information technology equipment safety
standard and IEC 60601-1 medical equipment
standard).Furthermore, all configurations must comply
with the standard IEC 60601-1.It is the responsibility of
the person, who connects additional equipment to the
signal input or output ports and configures a medical
system, to verify that the system complies with the
requirements of IEC 60601-1.If you have any questions
regarding these requirements, consult your sales
representative.
Prolonged and repeated use of keyboards may result in
hand or arm nerve disorders for some individuals.
Observe the local safety or health regulations concerning
the use of keyboards.
When using intra-cavity transducers, do not activate the
transducer outside the patient’s body.
The operator SHOULD NOT touch SIP/SOP and the
patient at the same time.
If the battery cannot be automatically maintained in a
fully usable condition, please conduct periodic checking
of the battery.