VS 8/VS 8A Vital Signs Monitor Operator’s Manual 15 - 1
15Managing Configurations
15.1 Configuration Introduction
When performing measurement or continuously monitoring on a patient, the clinical
professional often needs to adjust the monitor’s settings according to the patient’s
condition. The collection of all these settings is called a configuration. The system
configuration items can be classified as: parameter configuration items, conventional
configuration items, and user maintenance items. Allowing you to configure the monitor
more efficiently, the monitor provides different sets of configurations to accommodate
the varying patient categories and departments. You can change some settings from a
certain set of configuration and then save the changed configuration as a user
configuration.
The default configurations provided for your monitor are department-oriented. You can
choose any of the following department:
■ Med-surg
■ Emergency Department
■ Physician Office
■ Ambulatory Surgery Center
• The configuration management function is password protected. The
configuration management tasks must be performed by clinical
professionals.
15.2 Changing the Department
If the current department configuration is not the one you want to view, you can change
the department by following this procedure:
1. Select the Main Menu quick key → from the Configuration column select
Manage → input the required password → select .
2. Select Department Type.
3. Select a department.
4. Select OK.
15 - 2 VS 8/VS 8A Vital Signs Monitor Operator’s Manual
• Changing the department will delete all current user configurations.
15.3 Setting Default Patient Category
To set the default patient category when admitting a new patient, follow this procedure:
1. Select the Main Menu quick key → from the Configuration column select
Manage → input the required password → select .
2. Set Default Patient Category.
15.4 Setting Workflows
For details, refer to 3.9.1 Setting the Workflow.
15.5 Transferring a Configuration
When installing several monitors with identical user configurations, it is not necessary to
set each unit separately. Use a USB drive to transfer the configuration from monitor to
monitor.
15.5.1 Exporting a Configuration
To export the current monitor’s configuration, follow this procedure:
1. Connect a USB drive to the monitor’s USB port.
2. Select the Main Menu quick key → from the Configuration column select
Manage → input the required password → select .
3. Select Export Configuration.
4. Select the workflows and User Maintenance Settings to export.
5. Select Export.
15.5.2 Importing a Configuration
To import the configuration from the USB drive to the monitor, follow this procedure:
1. Connect the USB drive to the monitor’s USB connector.
2. Select the Main Menu quick key → from the Configuration column select
Manage → input the required password → select .
3. Select Import Configuration.
4. Select the workflows and User Maintenance Settings to import.
5. Select Import.
To Purchase, Visit Avobus.com or call 1-800-674-3655
To Next Page
Loading...
