1-2
1.1.1 Dangers
There are no dangers that refer to the product in general. Specific “Danger” statements may
be given in the respective sections of this manual.
1.1.2 Warnings
WARNING
z This equipment must be installed by factory authorized engineers and adequate
training of its use should be delivered to its user before it is put into use.
z There is high voltage inside the equipment. Never disassemble the equipment
before it is disconnected from the AC power source.
z This equipment can be disassembled by Mindray trained and authorized personnel
only.
z Be sure of static discharge before disassembling the equipment. Wear antistatic
wrist straps or gloves when disassembling the parts labelled with static-sensitive
symbolsto avoid damage to the parts.
z The equipment must be connected to a properly installed power outlet with
protective earth contacts only. If the installation does not provide for a protective
earth conductor, disconnect it from the power line.
z Dispose of the packaging materials, observing the applicable waste control
regulations and keeping it out of children’s reach.
1.1.3 Cautions
CAUTION
z Make sure that no electromagnetic radiation interferes with the performance of the
equipment when preparing to carry out performance tests. Mobile phone, X-ray
equipment or MRI devices are a possible source of interference as they may emit
higher levels of electromagnetic radiation.
z Before connecting the equipment to the power source, check that the power source
conforms to the requirements specified in the Operator’s Manual.
To Next Page
Loading...
