4
It is important to become familiar with the product before carrying out service on the scooter in
order to avoid injury to technicians and users. Read the relevant sections in the user’s instructions
and the service manual.
Pay particular attention to the following:
1. The main switch on the scooter MUST be turned off. Remove the ignition key. When
carrying out service on electrical components the positive pole on the battery MUST also
be removed.
2. When measuring voltage in connection with trouble-shooting be very careful not to create
a short-circuit.
3. Be very careful not to short-circuit the battery poles.
4. Take care when lifting heavy components such as seats, batteries, and motor gears, and
do not drop these.
5. Always lift one rear wheel in order to ensure that the scooter cannot move under power in
connection with incorrect operation.
6. Always use professional, properly maintained tools.
7. If lock nuts are removed in connection with servicing, NEW nuts MUST be used when
reassembling the scooter.
8. When installing new cable strips make sure they are installed in the same way as they were
originally. Make sure that cables cannot be pinched by moving parts or project so that
clothing can catch on them.
9. Always fi nish off servicing by making sure that the product is in roadworthy condition.
• Check that all plugs are correctly installed and that all mechanical components have
been properly tightened.
• Start the scooter and check that the solenoid brake clicks when the throttle is
activated. When the throttle is released it should not be possible to push the
scooter.
2.0 Safety service
To Next Page
Loading...
