75
SP1B
SK73750/7
PG DRIVES TECHNOLOGY
10
.
4.4 Reverse Decel’n ?
Adjusts the value for reverse deceleration (or braking) of the vehicle, in increments of
1. There are two settings:
Fast This value is used when the vehicle’s slow/fast switch is set to
fast.
Slow This value is used when the vehicle’s slow/fast switch is set to
slow.
The values are approximately displayed in “units” of 100ms and correspond to the
time taken to reach standstill from full reverse speed, i.e. the higher the value the
slower the deceleration.
It is the responsibility of the scooter manufacturer to ensure
that the emergency stopping distance is within the distance
specified for the country in which the scooter will be used.
For countries requiring CE marking this is as specified in
EN12184.
4.5 Forward Speed ?
Adjusts the value for forward speed of the vehicle, in increments of 1%. Note, this
speed will only be achieved if the speed limiting control is at the maximum speed
position. There are two settings:
Fast This value is used when the vehicle’s slow/fast switch is set to
fast.
Slow This value is used when the vehicle’s slow/fast switch is set to
slow.
4.6 Reverse Speed ?
Adjusts the value for reverse speed of the vehicle, in increments of 1%. Note, this
speed will only be achieved if the speed limiting control is at the maximum speed
position. There are two settings:
Fast This value is used when the vehicle’s slow/fast switch is set to
fast.
Slow This value is used when the vehicle’s slow/fast switch is set to
slow.
4.7 Throttle Pol’ty?
This selects the polarity of operation of a wig-wag throttle or, on a single-ended throttle
system, the polarity of operation of the reverse switch. You can set the Throttle Invert
Polarity to Yes or No.
On a wig-wag system, setting Throttle Invert Polarity to No means that if throttle
potentiometer wiper is approaching the high reference then direction will be forwards,
Yes is opposite to this.
To Next Page
Loading...