7
5.0 Service list, MC standard model
Area Component Checks and remedies
Rear suspension. Check to see if the rear end of the scoo-
ter is too low. The rear wheel should not
scrape against the splash guard when
the seat is loaded. Replace the blue sus-
pension blocks behind the battery. See
the spare parts catalogue.
Check to see if the rear suspension
and the transaxle are securely installed.
Tighten or install nuts and bolts.
Check that cables cannot be-
come caught in moving parts.
Install cable binders.
Check the wheels. Check to ensure they are properly tighte-
ned and that the rims are in good condi-
tion.
Check tyre pressure and wear
on tyres.
Recommended tyre pressure: 3.5 bar
(50 PSI). Minimum tread height for good
road holding is approximately 1 mm.
See spare parts catalogue for disassem-
bly.
NB! The rear wheels and front wheels on
4W models MUST always be removed
by loosening the fi ve screws. NEVER
loosen the fl ange itself by removing the
screw in the centre. See spare parts
catalogue. NB! Always defl ate the inner
tube before disassembling wheels.
Check that the handbrake
works.
Lubricate the rocker arm on the front
brake hub using acid-free oil. Adjust
cable length with the help of the adjust-
ment nipple. In cases of defective com-
ponents – see spare parts catalogue.
3W models: Front forks. Sus-
pension and straightness.
Check that the front forks are resilient.
Have they become crooked? Are there
oil leaks? If there are defects that must
be remedied replace the entire front
forks. See spare parts catalogue.
Suspension and
wheels.
To Next Page
Loading...
