27
15.0 Installing accessories
The following sections contain descriptions of how to install standard accessories on the Mini
Crosser T. In cases of doubt you can contact Mini Crosser A/S.
NB! Please read the precautions on page 4 »Safety service«.
15.1 Throttle regulation
Installing two throttle regulators on the same vehicle.
These could be:
• A standard throttle regulator, right and left (wig-wag)
• A twist grip throttle regulator, right and left (single-ended)
• A twist grip throttle regulator and foot pedal accelerator (single-ended)
It is common to them all that they use a changeover switch to select the type required.
Figure 1: Drill a 6.8 mm hole as shown. Figure 2: Remove the operating panel
Figure 3: Remove the standard throttle
regulator.
Figure 4: Install the plug from the contact.
To Next Page
Loading...
