push the wiper lever forward to position
0 or position 1, arrow 2.
The wiper lever returns to its initial po-
sition when released.
Rain sensor
Principle
The rain sensor automatically controls the
wiper operation depending on the intensity
of the rainfall. The sensor is located on the
windshield, directly in front of the interior
mirror.
Safety information
NOTICE
If the rain sensor is activated, the wip-
ers can accidentally start moving in car
washes. There is a risk of damage to prop-
erty. Deactivate the rain sensor in car
washes.
Activating rain sensor
To activate the rain sensor: Push the wiper
lever upward from position 0, arrow 1, once.
Wiping operation is started.
The LED in the wiper lever is illuminated.
In frosty conditions, wiping operation may
not start.
Deactivating rain sensor
To deactivate the rain sensor: Push the
wiper lever back to position 0.
Adjusting the rain sensor sensitivity
To adjust the sensitivity of the rain sensor,
turn the knurled wheel on the wiper lever
as follows:
– To set the rain sensor sensitivity to
high, turn the knurled wheel up.
– To set the rain sensor sensitivity to low,
turn the knurled wheel down.
Window washer system
Safety information
Warning
The washer fluid can freeze onto the win-
dow at low temperatures and obstruct the
view. There is a risk of accident. Only
use the window washer system when the
washer fluid will not freeze. Use washer
fluid with antifreeze, if needed.
NOTICE
When the washer fluid reservoir is empty,
the washer pump cannot work as intended.
There is a risk of damage to property.
Do not use the washer system when the
washer fluid reservoir is empty.
Seite 158
CONTROLS Light and view
158
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
