Cleaning the windshield
To clean the windshield, pull the wiper lever
back.
The washer fluid is sprayed on the wind-
shield, and the wipers are turned on briefly.
Windshield washer nozzles
The windshield washer nozzles are auto-
matically heated while standby state is
switched on.
Rear wiper
Switching on the rear wiper
To turn on the rear wiper, rotate the outer
switch on the wiper lever upward.
Switch posi-
tion
Function
Position 0. Rest position of the wiper.
Position 1. Intermittent operation.
When reverse gear is
engaged, the system
switches to continuous op-
eration.
Clean the rear window
To clean the rear window, turn the outer
switch on the wiper lever as follows:
– In rest position: Turn the switch down-
ward, arrow 3. The switch returns to its
rest position when released.
– In intermittent operation: Turn the
switch further, arrow 2. The switch au-
tomatically returns to its interval posi-
tion when released.
The function is deactivated if the washer
fluid reservoir fill level is low.
Fold-out position of the wipers
Principle
In the fold-out position, the wipers can
be folded out from the windshield, which
is important, for instance, when changing
the wiper blades or for folding away under
frosty conditions.
Safety information
Warning
If the wipers start moving in the folded
away state, body parts can be jammed or
damage may occur to parts of the vehicle.
There is a risk of injury or risk of damage
to property. Make sure that the vehicle
is switched off when the wipers are in
Seite 159
Light and view CONTROLS
159
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
