4. Unscrew the valve cap from the wheel
and screw the connecting piece of the
filler hose onto the valve.
5. With the compressor switched off, in-
sert the connector into the power socket
in the vehicle interior.
Filling the tire with sealing
compound
Safety information
DANGER
If the exhaust pipe is blocked or ventila-
tion is insufficient, harmful exhaust gases
can penetrate the vehicle. The exhaust
gases contain pollutants which are color-
less and odorless. In enclosed areas, ex-
haust gases can also accumulate outside of
the vehicle. There is a danger to life. Keep
the exhaust pipe free and ensure sufficient
ventilation.
NOTICE
The compressor can overheat during ex-
tended operation. There is a risk of dam-
age to property. Do not run the compres-
sor for more than 10 minutes.
Filling the tire with sealing compound
To fill in tire sealant, let the compressor run
for max. 10 minutes until a tire pressure of
2.5 bar/36 psi is reached.
1. With standby state or drive-ready state
switched on, switch on the compressor.
When adding sealant, the Tire Pressure
Monitor may briefly rise up to approx.
6 bar/87 psi before it shows the actual
tire pressure again. Do not turn off the
compressor at this stage.
2. Switch off the compressor when you
reach a tire pressure of 2.5 bar/36 psi.
Checking the tire pressure
To check the tire pressure, read the tire
pressure gauge on the compressor. The tire
pressure must be at least 2.5 bar/36 psi.
Tire pressure too high
If the tire pressure is too high, reduce the
tire pressure with the pressure reducing
valve on the compressor.
Minimum tire pressure not reached
Do not continue driving unless a minimum
tire pressure of 2.5 bar/36 psi is reached.
Contact an authorized service center or
another qualified service center or repair
shop.
Minimum tire pressure reached
When the tire pressure is at least
2.5 bar/36 psi, proceed as follows:
1. Pull the connector out of the socket in
the vehicle interior.
2. Disconnect the hose from the sealant
bottle and from the valve on the wheel.
3. Screw the valve cap onto the valve.
Seite 297
Wheels and tires MOBILITY
297
Online Edition for Part no. 01405B37A59 - II/24
To Next Page
Loading...
Need help?
General
