107
Pictures are
not sharp.
Subject is too close.
Make sure the subject is within
the autofocus range (p. 24) or
use the macro mode (p. 35).
The camera is in macro
mode.
Cancel the macro mode setting
(p. 35).
A special situation is pre-
venting the autofocus
system from focusing (p.
25).
Use the focus-lock function to
focus on an object at the same
distance as the subject (p. 24)
or use manual focus (p. 57).
Pictures are
taken indoors
or in low-light
situations with-
out flash.
Slow shutter speeds
result in blurred images
when the camera is
hand-held.
Use a tripod, change the cam-
era sensitivity to a higher set-
ting (p. 62), or use the flash (p.
26).
The subject is beyond the flash
range (p. 62).
Move closer to the subject or
change the camera sensitivity
to a higher setting (p. 62).
Problem Symptom Cause Solution
Focus signal is
red.
While using
flash, the pic-
tures are too
dark.
The camera temperature rises with extended periods of use. Care should be taken to avoid burns
when handling the camera, batteries, or memory card.
If the camera does not function normally or the system error message appears, turn it off, remove
and reinsert the batteries, or unplug and reconnect the AC adapter. If the camera has become hot
with extended use, wait for it to cool before removing or disconnecting the power supply. Always turn
the camera off using the main switch otherwise the memory card may be damaged and the camera
reset.
To Next Page
Loading...
Need help?
General
