Minolta EP1054 - Copying Procedure; Placing Originals; Sheet Originals (Standard Size); Highly Transparent Originals

3
Making Copies
3-4 EP1054
3.2 Copying Procedure
Placing Originals
Place the original face down on the Original Glass. Different methods are
used to load the originals depending on the type of originals .
Sheet Originals (Standard Size)
1 Raise the Original Cover.
Place the original face down on the
Original Glass, and align its rear left
corner with the Ö marker on the
Original Width Scale on the left side
of the platen.
2 Gently lower the Original Cover.
Highly Transparent Originals
1 Place the original in the same way as the sheet originals.
2 Place a blank sheet of paper of the
same size as the original over the
original. Then, lower the Original
Cover.
NOTE
è If this is not done, the copy produced may be of very poor quality.
3 Gently lower the Original Cover.