When an Indicator Lights Up
5
EP1085 5-7
Misfeed Indicator
If a paper misfeed occurs during a copy
cycle, that copy cycle stops. The Mis-
feed Indicator lights up and the Monitor
Display shows the location. At this time,
you cannot start a new copy cycle.
Misfeed Clearing Procedure
NOTE
è Be careful not to touch the areas marked with High Voltage and
Caution: HOT with bare hands.
è When the copier is equipped with a Multi Bypass Tray
1 Unload the paper stack from the
Multi Bypass Tray.
2 Open the Front Door and turn the
Lock Release Lever
counterclockwise to unlock and
swing up the Upper Half of the
copier.
3 Holding up the Fusing Unit, pull out
the sheet of paper.
CAUTION: HOT
è The Fusing Unit and its surrounding
areas may be extremely hot. DO
NOT touch any part except the
Fusing Unit Handle (yellow).
To Next Page
Loading...
