Minolta EP1054 - Call-Tech.-Rep. Indicator; Resetting the Call-Tech.-Rep. Indicator

5
When an Indicator Lights Up
5-10 EP1085
Call-Tech.-Rep. Indicator
When a malfunction occurs in the copier, the Call-Tech.-Rep. Indicator
lights up and the corresponding malfunction code appears across the
Zoom Ratio Indicator and Multi-Copy Display. At this time, you cannot
start a new copy cycle.
If this happens, try to clear the Call-Tech.-Rep. Indicator by following the
instructions below. If the Call-Tech.-Rep. Indicator lights up again, call
your Technical Representative immediately.
Resetting the Call-Tech.-Rep. Indicator
Open the Front Door, then close it. This
will reset the Call-Tech.-Rep. Indicator.
NOTE
è Carry out this procedure with the
Power Switch turned ON.
If the Call-Tech.-Rep. Indicator lights up again, call your Technical
Representative immediately.
NOTE
è When calling your Technical
Representative, give him or her the
malfunction code shown across the
Zoom Ratio Indicator and Multi-
Copy Display. Example: This is the
malfunction code C0010
A
100%
Meter Count
Toner
Drum Dehumidify
Paper
%
50%~200%
Auto
Lighter Darker
Book
Photo
Auto/Photo
141% A4 @ A3
115% B4
@ A3
100%
@@@ Full Size
81% B4
@ A4
70% A3
@ A4
A3 @@
A4 @@ B4
A4
@@ FLS.
A5
@@ Inch
50%~200%
1139O4960A
1139O4970A
Example:
Malfunction code
C0010