6
Troubleshooting
6-2 EP1054
The copy is blurry. The paper is damp. Replace the paper,
seepage5-4.
The copy has lines The Corona Units are dirty. Using the Corona Unit Cleaning
Levers, clean the Corona Units,
seepage8-4.
The copy has dark
specks or spots.
The Original Glass is dirty. Wipe the Original Glass clean
with a soft dry cloth,
seepage8-3.
The Original Pad or Document
Feed Belt is dirty.
Wipe the Original Pad clean with
a soft cloth dampened with mild
home detergent, see page 8-2
The original is very thin or highly
transparent.
Place a blank sheet of paper
over the original, see page 3-4.
The original is two-sided. The information on thebackside
of a two-sided, thin original may
be slightly reproduced on the
copy. Set the copier into the
Manual Exposure Mode and,
using the Exposure Control Key
(Lighter), make the exposure
level lighter, see page 3-10.
Theedgeofthecopy
is dirty.
The Original Pad is dirty. Wipe the Original Pad clean with
a soft cloth dampened with mild
home detergent, see page 8-2.
A paper size larger than the
original is loaded in the Drawer.
(Zoom Ratio is set at full size
100%.)
Load the same size copy paper
as the original into the Drawer,
seepage5-4.
Load the same size copy paper
onto the Manual Bypass Tray or
the Multi Bypass Tray, see page
3-13.
The original is not placed in the
correct direction. (Zoom Ratio is
setatfullsize100%.)
Reload the paper in the same
direction as the original, see
page 3-4.
The reduction ratio selected is
not in accordance with the copy
paper size. (When doing manual
reduction copying.)
Select the zoom ratio according
to the copy paper size, see page
3-7.
Symptom Possible Cause Action
To Next Page
Loading...
