Select whether or not to activate the auto clear function after the lapse of a given period of
time a after copy cycle has been completed or a key on the control panel has been operated.
Setting Value Description Initial Setting
0Disabled
1 Enabled : 30 sec.
2 Enabled : 1 min.
1151H19OBA
U-20 Auto Panel Reset ON/OFF
Select whether or not to set the copier into the Energy Saver mode after the lapse of a given period
of time after a copy cycle has been completed or a key on the control panel has been operated.
The period of time can fall within the range 1 to 120 min.
*The initial setting is 15 min.
Setting Value Description Initial Setting
1
Enabled : 1min.
2
Enabled : 2min.
3
Enabled : 3min.
:
:
:
:
98
Enabled : 98min.
99
Enabled : 120min.
Select whether to set the copier into the initial mode when the Plug-In Counter is pulled out.
Setting Value Description Initial Setting
0 Copier is not initialized.
1
Copier is initialized when the Plug-In Counter is pulled out.
1151H20OBA
1151H22OBA
U-21 Energy Saver ON Timing
U-23 Auto Panel Reset for Plug-In Counter
Chapter 4
Special Functions
3. User’s Choice
56
To Next Page
Loading...
