Minolta EP2010 - Page 85

7. When the I. U. Service Life Indicator Lights Up
Carefully pull the polyester tape from
the I. U..
4
Remove the Cap from the I. U. and
re-fit it to the used I. U. as shown in
the illustration.
5
Be sure to push the I. U. into the
locked position until a click is heard.
Then, check to see the position of Lock
Release Lever, as shown in the
illustration.
8
Slightly lift up the Upper Half of
thecopier and unlock Stopper M2 .
Gently swing down and lock the Upper
Half of the copier. Then, close the
Front Door.
9
Align the I. U. with the Rails in the
copier.
6
Slide the I. U. all the way into the
copier.
7
4445U011AA
4445U004AA
4488O001AA
1139O0540A
4445U005AA
1151O144AB
An improperly installed I. U. could be a
cause of copier malfunction.
NOTE
Chapter 5
When an Indicator Lights Up
80