7. When the I. U. Service Life Indicator Lights Up
The copier automatically start the
charging cycle for approximately
5 minutes.
During this cycles, do not open the
Front Door.
During this cycle, six segments of the
ones digit LED on the Magnification
Ratio Indicator forming a "0" light up
and go out one after another,
indicating that the copier is being
charged with starter.
When the copier has been completely
charged with Starter, the indication on
the Magnification Ratio Indicator
changes to "100" and the cycle stops.
7
If "E1" or "E2" is indicated on the
Magnification Ratio Indicator, the tape
has not been removed from the Starter
Bottle. Swing down the Front Door
and remove the tape and perform the
starter charging procedure again.
If "E1" or "E2" is indicated again call
your Technical Representative.
8
Swing down the Front Door, swing out
the Bottle Holder, and remove the
Starter Bottle.
9
Hold the Toner Bottle so that its tab is
on the upper side, shake it well, and
peel off the tape.
Once the tape has been removed, hold
the Bottle so that its Toner Port faces
up.
10
1139O012AA
4445U009AA
1151O099DA
1151O099DA
Chapter 5
When an Indicator Lights Up
82
To Next Page
Loading...
