Interleaf EP5000/EP4000 SWITCHES ON PWBs, TECH. REP. SETTINGS
97.04.01
S-14
1156SBS040406A
[6/6]
Touch Panel
Display
Setting (The default is .)
Highlighted
Orig. " Copy
Default
Select the type of Orig. " Copy setting selected automatically when the copi-
er is turned ON or Panel Reset key pressed. If ”Duplex only” is selected for
“Simplex/Duplex” of the “Tech. Rep. Choice” function, neither 1 " 2 nor 1 "
2in1 are displayed.
NOTE: Some of the functions may not be displayed depending on the type of
options the copier is equipped with.
1 " 2
1 " 2 in1
1 " 1
1 " 2-2 in1 2 " 2
Auto Power-OFF
Mode
Select whether to turn ON or OFF the Auto Shut Off function that shuts down
the copier a given period of time after a copy cycle has been completed or the
last key operated.
Selecting “ON” means setting the time it takes the Auto Shut Off function to
be activated, that can range from 1 min. to 240 min.
NOTE: “OFF” is displayed when “Enable” is selected for “Non-Auto Shut off”
of the “Administrator Mode” function.
OFF 1 to 240
EP4000: 90 min.
EP5000: 60 min.
Original on Glass Select whether to turn “ON” or “OFF” the beep that sounds when you attempt
to load an original in the document feeder with another one left on the glass.
Beep OFFBeep ON
Administrator Mode The entry of the “Administrator #” set using the Tech. Rep. mode permits the
settings of the following functions.
Copy Track
100 Accounts 1000 AccountsOFF
Select the number of accounts to be controlled.
Copy Track
YES (initialize) NO (do not initialize)
This function is displayed when the above “Copy Track” setting is
changed, prompting you to select whether to initialize (“YES”) the
copy track data so far taken or not (“NO”)
Copy Track Data When “Count Reset” is touched, it clears all data under control.
To Next Page
Loading...
