3. Manual Bypass Copying
Use the Manual Bypass to make copies on paper not loaded in any drawer, or to copy onto
transparencies, translucent paper, or any other special paper. When using the Multi Bypass Tray,
you can load multiple sheets of copy paper.
Copy Paper That Can be Used for Manual Bypass
Non-Sort and 1-Sided Copy 2-Sided Copy Sort/Group/Staple/Punch
Type of
Paper
Plain paper (weighing 60g/m
2
to 90
g/m
2
)
Heavyweight paper (weighing 91
g/m
2
to 157g/m
2
)
Transparencies, translucent paper
Plain paper (weighing 60g/m
2
to 90
g/m
2
)
Heavyweight paper (weighing 91
g/m
2
to 157g/m
2
)
Plain paper (weighing 60g/m
2
to 90
g/m
2
)
Paper
Size
A3L to A6L
Width : 100 mm × 297 mm
Length : 140 mm × 432 mm
A3L to A5L Sort/Group : A3L to A6L
Staple : A3L to A5L
Punch : A3L, A4C
Capacity
Plain Paper … Up to 50 sheets
Plain Paper (once-copied paper) … Up to 20 sheets
Thick paper, transparencies, translucent paper … Up to 20 sheets
Using the Manual Bypass
Place the original on the Original
Glass and make the control panel
settings.
1
The following functions cannot be
selected for Manual Bypass if "Manual
Feed Expansion" of User’s Choice has
been turned "OFF" : Auto Size, Auto
paper, Finishing, and 2-sided copying,
Margin-by-Reduction, 1[2in1] 1 and
2[2in1] 1.
NOTE
▲
▲
Swing down the Multi Bypass Tray
and slide the Paper Guide Plate to the
size of the copy paper.
2
Place a neat stack of copy paper on the
Table and insert it into the copier until
it stops.
3
•
Before inserting, fan the paper stack
well if you are using transparencies or
translucent paper.
•
Correct any curl if you are using
heavyweight paper.
•
When using once-copied paper, load
the paper stack so that the blank side
faces up.
•
The paper will be copied on the side
facing up.
NOTES
1136O079AA
1136O080AA
Chapter 3
Making Copies
32
To Next Page
Loading...
