7. Auxiliary Functions
The Interrupt function allows you to interrupt a
current job and run a different one. Pressing
the Interrupt key once sets the copier into the
Interrupt mode. Pressing the key again lets the
copier leave the Interrupt mode, returning to
the previous settings.
Interrupt
•
If the current job involves 2-sided
copying, Cover function, Page Insertion
or OHP Interleaving, the copier rejects
an Interrupt cycle.
•
If the current job involves a finishing
function other than Non-Sort, Non-Sort is
automatically selected at the same time
when an Interrupt function is invoked.
Useful Tips
When the initial screen reappears, you
can now start a copy cycle.
2
From the 10-Key Pad, enter the 4-digit
access number and press the Access
Mode key.
1
•
If an access number has been
programmed, a copy cycle can be
initiated only after the access number
has been input to the copier.
<"Access #" Prompt Screen>
NOTES
By pressing the Mode Check key on the
control panel, you can either check for or
change the current settings.
Mode Check
•
When you touch Exit after having checked
the currently set functions, the Basic screen
reappears.
•
To change a certain function, touch the
corresponding key and then make the
necessary change.
When the copy cycle is completed,
press the Access Mode key again.
3
If an access number has been programmed, it
allows only particular persons to use the copier
or a supervisor to keep track of the number of
copies made by a particular department.
Access Number
•
Before you can use this function, you
must first turn "ON" the "Copy Track"
function of the Administrator Mode
available from User’s Choice.
➭
p. 88
Entering the Access Number
123
456
789
0C
1134P438DA
To correct the 4-digit access number
entered, first press the Clear key, then
enter the new number.
NOTE
1134P438DA
1149O259CA
1149O271CA
Chapter 2
Getting to Know Your Copier
22
To Next Page
Loading...
