1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it in a location which
meets the following requirements.
u
A place away from a curtain or the like that
may catch fire and burn easily.
u
An area where there is no possibility of
being splashed with water or other types of
liquid.
u
An area free from direct sunlight.
u
A place out of the direct air stream of an air
conditioner, heater, or ventilator.
u
A well-ventilated place.
u
A dry place.
u
A dust-free location.
u
An area not subject to undue vibration.
u
A stable and level location.
u
A place where ammonia or other organic
gas is not generated.
u
A place which does not put the operator in
the direct stream of exhaust from the copier.
u
A place which is not near any kind of
heating device.
Power Source
The power source voltage requirements are as follows.
Space Requirements
To ensure easy copier operation, supply replacement, and service maintenance, adhere to the
recommended space requirements detailed below. Allow a clearance of 150mm or more at the back
of the copier as there is a ventilation duct.
Unit: mm
u
Use a power source with little voltage fluctuation.
Voltage Fluctuation
:
Within ±10%
Frequency Fluctuation
:
Within ±0.3%
1156O008AA
1,870
300
2,370
200
1156O009AA
150
1,310
Chapter 1
Safety Notes
2
To Next Page
Loading...
