Minuteman E24 - 6.1 Brush Switch

6.1 Brush Switch
6.1 Brush Switch
•The brush motors are switched on and off by a micro-switch located at the rear at the
brush head lift
-
out system Figure 6/3 This switch is a NO (normally open) switch To
brush
head
lift
out
system
Figure
6/3
.
This
switch
is
a
NO
(normally
open)
switch
.
To
attain safe function of the brush motors, the correct adjustment of this switch is
required.
•Electric connection of the switch is connected to the central control circuit board at
A1 X9:4 + 10 connector In the lifted
-
up position the switch should open and close
A1
.
X9:4
+
10
connector
.
In
the
lifted
-
up
position
,
the
switch
should
open
and
close
when brush head is lowered.
Fig. 6/3
22