Minuteman E24 - 11.5 Programming the Charger

11.5 Programming the Charger
10.5 The automatic scrubbers are equipped with the new on board automatic charger.
The charger will be programmed from the factory for the wet lead acid batteries.
Machines that were purchased with gel maintenance free batteries installed at the
Machines
that
were
purchased
with
gel
maintenance
free
batteries
installed
at
the
factory will be programmed for gel.
1. The charger can be programmed to charge either the gel type battery or wet lead
acid batteries.
2. Follow the instructions below to chan
g
e the char
g
in
g
mode.
ggg
3. Remove the two Allen head screws on the rear of the machine. Let the
charger/controller-cover drop down. The charger is located on the rear of the
housing.
4. Remove the nut and washer on the backside. Carefully lift the plastic cover off
dtittthid
an
d
se
t
it
t
o
th
e s
id
e.
5. Plug the charger’s A.C. power cord into the outlet. The charger will turn on.
6. Locate the small push button switch on the right side of the charger. Located near
the rubber strap.
ProgrammingButton
46