Minuteman E24 - 11.4 24 V - 14 A Charger

11.4 24V - 14A Charger
•10.4 Charger Maintenance Points
•Check the following, when servicing the machine:
•The charger unit should be secured by rubber strap.
•The wires
g
oin
g
to and from the char
g
er should be secured with
p
lastic
gg g p
wire ties. They should be routed so that there are not any kinks, pinched
or crushed wires.
•The charger housing must be insulated from all metallic machine parts.
Use a multi
-
meter to measure the resistance between charger housing and
Use
a
multi
meter
to
measure
the
resistance
between
charger
housing
and
the frame on the machine. There should not be continuity.
•Repeat the test by checking the resistance between the A.C. Cord ground
pin of the charger and frame of the machine. There should not be
continuity
continuity
.
•The ground pin of the A.C. cord must conduct without resistance to the
screws on the charger case.
•The char
g
er ventalation hose must in
p
lace and without obstruction.
gp
45