Minuteman E24 - 11.6 Replacing the Charger Harness

11.6 Replacing the Charger Harness
•When replacing the charger output harness (W8) 97094346 on
19 gallon models or 011722530 on 30 gallon models with the
electric brake.
•Use the K-E24261668 Charger Retro fit kit in addition when either the
harness or charger is being replaced.
•Inspect the receptacle on the charger for burnt or damage.
Replace the charger if it is damaged.
•
Use a coating of high temperature dielectric grease
Use
a
coating
of
high
temperature
dielectric
grease
(NYOGEL 760G GREASE) or equivalent, on the pins of the plug
of the harness, before connecting the new harness to the charger.
50