Mira COMBIFLOW - Page 18

18
Blanking Plugs
Inlet Nipples
Quad Key
2.4 Use the quad key or a suitable
screwdriver to remove the blanking
plugs.
2.5 Use the quad key to remove the inlet
nipples from the rear of the mixer
valve.
2.6 Screw the inlet nipples, complete with
'O' seals, into the blanking plug holes
flat face end first.Tighten the inlet
nipples with the quad key.
2.7 Fit the blanking plugs complete with
'O' seals, into the rear inlet nipple
holes.Tighten the blanking plugs.
2.8 Locate the Combiflow shower control
on to the wall.
Note! Make sure that the screws
supplied with the product are used for
mounting the shower.
2.9 Use a suitable screwdriver to tighten
the two screws through the body. The
screws will hold the shower control in
position.
Blanking Plugs
Inlet Nipples
'O' Seal
Quad Key
For latest prices and delivery to your door visit MyTub Ltd 0845 303 8383 www.mytub.co.uk