56
Front Panel Menu Operation
At this point the display varies, depending on your choice:
• If you selected “yes”, the display shows the message “Counters cleared “, then it
returns to the Command Menu.
• If you selected “no”, the display shows the message “Operation cancelled”, then it
returns to the Command Menu.
5.12 10. Network Restart
Use the Network Restart after downloading the FleX-Net™ FX-4000 configuration.
At this point the display varies, depending on your choice:
• If you selected “no”, the display shows the message “Operation cancelled”, then it
returns to the Command Menu.
• If you selected “yes”, the system begins a reset and the display shows the following
message:
Step 3: Select “yes” or “no”
1. Use and to select “yes” or “no”.
2. Press to continue.
Step 1: Select Network Restart
1. Use and to scroll the cursor to “Network
Restart”.
2. Press to continue.
Step 2: Enter your passcode (if required)
Enter the passcode. See page 16 for instructions on
entering passcodes.
Default is Level 2 passcode required.
Step 3: Select “yes” or “no”
1. Use and to select “yes” or “no”.
2. Press to continue.
Clear all
verification
counters?Y
- Command Menu -
8 Clear event log
9 Clr Verif Count
10 Network Restart
Enter passcode for
level 2 or higher:
Are you sure you
want to reboot whole
network (all nodes
and CPUs)?Y
Initial system self
checks in process ...
Version 1.6.3
To Next Page
Loading...