17
Start Up
Level 1
• Device bypass
• Zone bypass
• Node bypass
• Buzzer bypass
•Set time
• Walktest
Level 2
• Clear event logs
• Clear verification counters
• Configuration change
• Network restart
• Manual control
• Input simulation
4.3 Menu Mode
Press the button to activate the menu mode. The menu is organized as follows:
Note: You can change these access levels in the MGC-4000 Configurator.
Menu Submenu Description How to Use
1. Reports
Alarm Log View or print all the alarm events. See page 21
Event Log
View or print all events: alarms, troubles, and
button pushes.
See page 22
Current Levels
View or print the current alarm level for analog
devices.
See page 22
Sensitivity Levels View or print the sensitivity level for detectors. See page 24
Verification Count
View or print the number of times that devices have
gone into pre-alarm status.
See page 25
Maint Report
View or print detectors that are reading dirty or
almost dirty.
See page 26
Obscuration
View or print addressable detectors that have
obscuration level capability.
See page 27
CO Report View or print the months remaining on CO cells. See page 28
Serial Code View or print the devices’ serial numbers. See page 29
Power Source Report
View or print the primary (A/C) and FWR
secondary (battery) power source.
See page 30
Output Active View or print all active outputs. See page 31
To Next Page
Loading...
Need help?
General