18
Start Up
2. Bypass
Device/Circuit Bypass or unbypass a device or circuit. See page 33
Node Bypass or unbypass a node. See page 34
Loop Bypass or unbypass a loop. See page 35
Relay disc Disconnect or reconnect all relays. See page 36
Input Zone Disconnect or reconnect an input zone. See page 36
Output Zone Disconnect or reconnect an output zone. See page 37
Node Outputs Disconnect or reconnect all outputs on a node. See page 39
Positive Alarm Sequence Bypass or unbypass the positive alarm sequence. See page 39
Buzzer Bypass or unbypass the buzzer. See page 40
Audio
Bypass or unbypass the audio signals going to
amplifiers.
See page 41
3. Manual Control NA Manually activate an output. See page 42
4. Input Simulation NA Manually activate an input. See page 43
5. Walk Test
Assisted (if configured) Preform an assisted walk test for large systems. See page 45
Audible Test Perform an audible walk test. See page 47
Silent Test Perform a silent walk test. See page 49
6. Day/night mode NA
Select day or night mode, if the modes are
configured for different sensitivity levels.
See page 53
7. Set Time NA Set the time. See page 54
8. Clear Event Log
Alarm Log Clear the alarm log. See page 54
Event Log Clear the event log. See page 54
Walktest Report Clear the walk test report. See page 54
All Logs Clear all the logs. See page 54
9. Clear Verification
Count
NA Clear all alarm verification counters. See page 55
10. Network Restart NA
Restart the system after system configuration
download is completed.
See page 56
11. Configuration
Config Info View the configuration information. See page 57
Select Version Select the version of the job to make active. See page 58
Factory Reset the system to factory defaults. See page 59
12. Signal Silence
Inhibit Timer
NA
Enable or disable the signal silence inhibit timer
(the time during which you cannot silence the
alarm or reset the system).
See page 59
Menu Submenu Description How to Use
To Next Page
Loading...
Need help?
General