Mircom FX-2000 series

100
Appendix H: Label Requirements for Zone Identification
19.0 Appendix H: Label Requirements for Zone
Identification
For individual zones, the labelling of these zones must be in accordance with ULC/CAN S527-11 Table 2; of
which is partially included below:
LABEL DESIGNATIONS IN ENGLISH DESCRIPTION OF FUNCTION
XXX
a Alarm Signal Activation or
XXX
aAlarm Signal ON
Circuit Or Area Evacuation Manual
Control
XXX
a Alert Signal Activation or
XXX
a Alert Signal ON
Circuit Or Area Alert Manual Control
XXX
a By-pass Ancillary Bypass
XXX
a ON Ancillary Device Indication
XXX
a OFF Ancillary Device Indication
Building Safety or Bldg Safety Common Indication Associated With
Property And Building Safety
XXX
b Specific Indication Associated With
Property And Building Safety
Emergency and building events Common Indication Associated With
Emergency And Building Events
XXX
b Specific Indication Associated With
Emergency And Building Events
XXX
b Emergency Or Building Event Manual
Control
XXX
a Bypass Bypass Output Function
Activate XXX
a or equivalent followed
by
XXX
a
Initiate Manual Control Function
Remote Connection Bypass or
equivalent
Bypass Connection For Fire Service
Response
Signal Circuit Trouble Signal Circuit Fault Indication
Signal Silence Inhibit Prevent Silence Of Signal For A Preset
Time
Supervisory Common Indication Associated With
Supervisory Inputs
XXX
a Specific Indication Associated With
Supervisory Input
Supervisory Signal Silence Manual Signal Silence Control For
Supervisory Signal
Trouble Common Trouble Signal Indicator
XXX
a Trouble Specific, Circuit Or Area Trouble
Signal Indicator
ａ ｒｅｐｌａｃｅ ＸＸＸ ｗｉｔｈ ｌｏｃａｔｉｏｎ ａｎｄ／ｏｒ ｄｅｖｉｃｅ ｓｐｅｃｉｆｉｃ ｄｅｓｃｒｉｐｔｉｏｎ．
ｂ ｓｕｃｈ ａｓ ａｌａｒｍｓ， ｌｉｆｅ ｓａｆｅｔｙ， ｓｕｐｅｒｖｉｓｏｒｙ， ｂｕｉｌｄｉｎｇ ｓａｆｅｔｙ ａｎｄ ｔｒｏｕｂｌｅ