Mircom FX-2000 series User Manual

19
Mechanical and Chassis Installation
4.2 Chassis Installation
Chassis Installation Instructions for the following:
• FX-2003-6DS
• FX-2003-12DS
• FX-2003-12XTDS
• FX-2009-12DS
• FX-2009S-12DS
• FX-2017-12ADS
• FX-2017S-12ADS
• ECX-0012
For proper chassis installation do the following
1. Group the incoming wires through the top of the enclosure to prepare it for wiring the
modules. Do not run the wires in-between the modules since it could cause a short
circuit.
2. Use a wire tie to group wires for easy identification and neatness.
3. Be sure to connect a solid earth ground (from building system ground / to a cold water
pipe) to the chassis earth ground mounting lug, and to connect the earth ground wire
lugs from the main chassis to the ground screw on the backbox.
4. Mount chassis using the supplied hex nuts.

Mircom FX-2000 series Specifications

General

Type	Fire Alarm Control Panel
Display	LCD
Network	Optional
Communication	RS-232, RS-485
Programming	Via keypad or PC
SLC Loops	1
NAC Outputs	4
Communication (Additional)	Optional Ethernet
Input Voltage	120 VAC or 240 VAC, 50/60 Hz
Battery Charging Current	1.5 A
Auxiliary Power Output	24 VDC
Operating Temperature	0°C to 49°C (32°F to 120°F)
Relative Humidity	Up to 93% non-condensing