Mircom FX-2000 series User Manual

2
Introduction
• Common controls and indicators for System Reset, Lamp Test, Fire Drill, Signal Silence,
General Alarm,
• General Alarm Cancel, AC On, Pre-Alarm, and Ground Fault.
• Two Spare configurable Keys and LED Indicators.
• 16 configurable LEDs (bi-coloured) with slide-in labels, available with the DSPL-420-
16TZDS display.
• Provides drift compensation for photoelectric smoke detectors.
• Provides Signal Coding of signal circuits for easy alarm identification (code consists of 1
to 4 digits, each digit consisting of 1-15 pulses on the signal).
• Selection for Canadian (ULC) or USA (ULI) requirements for Smoke Sensor sensitivity.
• Extensive transient protection.
• Surface Mountable Enclosures with removable doors for easy installation and service.
Flush Trims available.
• Removable Terminal Blocks for easy wiring and service.
• Loop Adder modules ALC-198S and ALC-396S for expanding addressable loops by 1
and 2 respectively.
• Adder module ALC-H16 hardwire loop interface board for expanding conventional input,
output, relay capability.

Mircom FX-2000 series Specifications

General

Type	Fire Alarm Control Panel
Display	LCD
Network	Optional
Communication	RS-232, RS-485
Programming	Via keypad or PC
SLC Loops	1
NAC Outputs	4
Communication (Additional)	Optional Ethernet
Input Voltage	120 VAC or 240 VAC, 50/60 Hz
Battery Charging Current	1.5 A
Auxiliary Power Output	24 VDC
Operating Temperature	0°C to 49°C (32°F to 120°F)
Relative Humidity	Up to 93% non-condensing