Mircom TX3 Series - Viewing Configuration Information; Entering Configuration Mode; Figure 1. Viewing Configuration Information; Figure 2. Entering Configuration Mode

Configuration
Version 1.1 Telephone Access System User Guide 13 (42)
LT-968 Copyright 2012
2.3 Viewing Configuration Information
To view configuration information, you must first enter the configuration mode.
To enter configuration mode
Figure 1. Viewing Configuration Information
2.4 Entering Configuration Mode
To make changes to the resident list at the panel, you must first enter the
configuration mode.
To enter configuration mode
Figure 2. Entering Configuration Mode
1. Press .
2. Press the (scroll down) to “View Cfg Info”.
Press the key to enter.
3. The configuration information displays. You may
need to scroll to view all the information.
Main Menu
1. Configuration
2. Operation
3. View CFG Info
1. Press .
2. Select Configuration menu.
3. Enter the passcode.
4. If you have not set a personal password,
press
(four-digit factory default).
5. If you have set a personal passcode, enter your
passcode.
You are now in configuration mode.
Enter the Passcode
[ _ _ _ _ _ _ _ _ _ ]