Mircom TX3 Series - Page 24

24 (42) Telephone Access System User Guide Version 1.1
LT-968 Copyright 2012
Configuration
4. When you are finished adding the new record, press Enter (the telephone
key) the display shows “New Record Added”. The display returns to the
configuration menu.
2.15.3 Using keyless entry codes
To enter the premises with a keyless entry code, you must first be in normal mode.
While in normal mode, press 0, after which point you are prompted with “Enter
keyless code”. The keyless code is a numeric value from 1 to 999999.
To enter your keyless code
1. Press 0. The keyless enter code appears.
2. Enter your keyless code.
Enter Elev Rest Addr
[_ _]
YES YES Enter the ID (or address) of the Elevator
Restriction controller for the resident.
Enter Elev Rest Relay
[_ _]
YES YES Enter the elevator restriction relay number for
the resident.
Keyless Corr
[x] Main door relay
[ ] Aux door relay
YES YES Select which door (main, auxiliary or both)
can be opened by the resident using a keyless
code.
Line to Use
[x] Line 1 - 5
YES YES Enter the speech path for resident to
communicate to the ADC line or to a relay
control unit. Line 1 is default.
Enter Ring Pattern
[x] Ring Pattern 1-5
YES N/A Enter the ring pattern for the resident. See
Table 2 for available ring patterns. The
default is 1.
Table 1: List of Screens