80 Mitel 6873 SIP
eud-1744/1.4 – R5.0 HF2 – 10.2017
Personalizing your phone
Configuring general phone settings
This section explains other settings you can make on your phone.
Selecting the language
You wish to select a different user language for your display.
To change both the local user language and the user language of the
MiVoice Office 400 communication system, configure the language set-
tings for your phone over the Self Service Portal only. For more information
about the Self Service Portal, please refer to "MiVoice Office 400 Self Ser-
vice Portal", page 9.
The language selection depends on the language packages your system
administrator installed on your phone. English is the default language and
is included in every language package. Should your desired language not
be available, your system administrator can install more language pack-
ages.
If your desired language is available, but is not displayed or displayed only
in parts, you have to restart your phone (see chapter "Restart phone",
page 83).
Add and connect Bluetooth headset:
1. Press Bluetooth.
2. Press Available devices.
➔All available Bluetooth headsets are searched and displayed automatically.
3. Select the desired Bluetooth headset.
➔The selected headset is connected automatically. Please see the product
specific user's guide of your Bluetooth headset for individual steps you
have to carry out for your headset.
4. Confirm successful connection with the Ok softkey.
➔Your headset can be used, is displayed.
Disconnect Bluetooth headset:
1. Press Bluetooth.
➔Bluetooth mode must be activated.
2. Press Connected devices.
3. Press the key for the desired headset.
4. Confirm the security question with Yes.
To Next Page
Loading...
Need help?
General
