Phoning
Mitel 6873 SIP 33
eud-1744/1.4 – R5.0 HF2 – 10.2017
Dialling with a configurable key/ busy lamp field
You want to call someone whose phone number is stored under a config-
urable key or a busy lamp field.
To find out how to configure a configurable key, refer to chapter "Configur-
ing keys", page 89.
Dialling with the line key
You want to make a call via a line key.
You can make a call via a line key. Your phone is equipped with two dedi-
cated line keys with LED (L1, L2). Your system administrator can set up to
ten additional line keys (making a total of twelve). The actual number of
line keys depends on the system configuration.
Press a set line key directly or move you finger from the right to left in the
area to the right of the left softkeys and select the desired line key. The sta-
tus line at the top left will show the dialled line number (L1, L2 etc.). If a line
is free, the New call softkey at the bottom left of the display can be used.
Redial list:
Press the Redial key.
➔List of most recent selected entries (including the presence status of the con-
tact) is displayed.
Scroll through the list and select the user you want.
Pick up the handset or press the Dial softkey.
➔The call number of the user is dialled.
Phoning with the handset:
1. Pick up the handset.
2. Press the desired configurable key/busy lamp field.
➔The phone number is dialled.
Using your phone in handsfree mode:
Press the desired configurable key/busy lamp field.
➔The phone number is dialled.
To Next Page
Loading...
Need help?
General
