Mitel 6869i - Receiving Calls; Answering an Incoming Call

Handling Calls
149
If any party in the conference hangs up (including the party that began the conference), all other
parties in the conference are still connected.
Setting Up Multiple Conferences (for Sylantro Call Manager only)
1. Start Conference 1 using the procedures in the previous section, “Setting Up a Conference
and Adding Multiple Parties (for Sylantro and BroadSoft Call Managers)” on page 148.
2. When you are finished adding all required parties to Conference 1, press an available Line
key or navigate to the Line Selection screen to place a new call using an available line to
start Conference 2. You are Party 1 on Conference 2. Call Party 2.
3. When Party 2 answers, press the Conf softkey.
4. Press an available Line key or navigate to the Line Selection screen to place a new call
using an available line.
5. Call Party 3 for Conference 2.
6. When Party 3 answers, press the Conf softkey to join Party 2, Party 3, and yourself to form
a conference call. You now have two active conferences on two different lines.
If any party in a conference hangs up (including the party that began the conference), all other
parties in the conference are still connected.
Note: The 6869i is limited to 24 conferences (a single conference each on lines 1 through
24).
IP PHONE UI
Note: When you are connected to multiple conference calls and you put a conference
on hold, the conference may be on hold for a limited period of time before it is
disconnected. Contact your System Administrator for more information.