Mitel 6940 SIP - Page 42

42 Mitel 6940 SIP
eud-1765/2.0 – R6.0 – 06.2018
Phoning
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 102
).
Notes: • Your call number can only be hidden if you select an external call num-
ber.
• This feature depends on the range of services offered by your provider.
Putting a call partner on hold
You want to briefly interrupt the active call.
You can put the call party on hold and then take them back again on the
same phone.
Menu Description
Permanent The call number is never displayed.
Per call Call number should only be restricted for certain calls.
This function must be activated before dialing the call
number.
Activating/deactivating calling line identification restriction permanently:
Press the function key for Hide number.
➔Function is activated/deactivated. You phone number is hidden in all outgoing
calls.
Activating CLIR per call:
1. Press the function key for Hide number.
2. Enter the call number and press the Select softkey.
➔Call number is dialed and your number is not displayed to the called party.
Putting the active call party on hold:
Press the Hold key.
➔The call party is put on hold, is displayed and the LED of the line key flashes.
Take back the call party on hold:
Press the Hold key, the flashing line key, or the Pick up softkey.
➔The call is active again.