46 Mitel 6940 SIP
eud-1765/2.0 – R6.0 – 06.2018
Phoning
Take (pick up own call)
You want to transfer a call from one phone to another without interrupting
the connection (for example, from a desk phone to a cordless phone).
The take function can be used to transfer calls between your phones.
Requirements: You are using the one number user concept (see chapter
"One number user concept", page 8
).
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 102).
Starting announcement
You want to speak directly to an internal user or an announcement group
via the loudspeaker - where available - without expecting an answer (simi-
lar to an intercom). The recipient is alerted to the announcement by two
short signal tones. You are immediately unilaterally connected via the
loudspeaker.
If the internal user has secured their phone against announcements (con-
figuration see chapter "Activating protection against call types", page 96
),
you cannot contact them using an announcement. You will get the
engaged tone.
The announcement function must be saved to a configurable function key
with Self Service Portal (see "Configuring or deleting a key assignment",
page 102). You can either configure the function key directly with a desig-
nated user or input the call number manually each time.
Starting the emergency announcement:
Menu Description
Call transfer with prior
notice
You only transfer the call after you have first talked to the
second call party yourself.
Call transfer without
prior notice
Without talking to the second call party, you transfer the
call to them by hanging up the handset immediately after
dialing the call number.
Picking up your own call (you are in an active call):
Press the function key for Take.
➔After a brief moment, you are connected with the caller on another phone.
To Next Page
Loading...
