54 Mitel 6940 SIP
eud-1765/2.0 – R6.0 – 06.2018
Phoning
You can also store your individual call routing profiles over the Self Service
Portal on a function key and quickly activate or deactivate your desired call
routing profile by simply pressing that key.
Activating Ring Alone
You want to specify the phone on which an incoming call is signaled
acoustically.
If your system administrator has set up one phone number for several
phones (see "One number user concept", page 8
),you can use Ring Alone
to define on which phone a call will be signaled acoustically. As soon as
you activate Ring Alone on one phone, the ring tone is deactivated for all
other phones. An incoming call is signaled in the display of all phones. You
can answer the call on any of the phone; once the call is answered, other
phones go back to the idle state.
You must save this function to a configurable key using Self Service Portal
(see chapter "Configuring or deleting a key assignment", page 102
).
Note: When you have activated ring alone but deactivated the personal call rout-
ing for a phone in parallel, an incoming call is not acoustically but only
visually signaled.
Scroll to the Personal call routing.
➔A list of your routings is displayed.
1. Scroll to the call routing you want to rename and press the softkey Modify.
2. Enter the name and confirm with the Select softkey.
Press the function key for the desired call routing profile.
➔Call routing is activated/deactivated; LED of the function key (on expansion
key module), and the LCD on the phone is switched on/off.
Activating/deactivating ring alone
Press the function key for Ring Alone on/off.
➔Function is activated/deactivated, LED on the expansion key module and the
LCD on the phone is switched on/off.
To Next Page
Loading...
