Mitsubishi Electric CR800 Series - Backup Robot Data to USB Memory

3 Description of functions
3-77
• Device code
Specify the following device codes.
Device Category
Device code
Device No. range
ASCII code *1
Binary code
CPU buffer
memory
Word
G***
00ABH
Specify within the range of
device numbers held by the
access destination unit.
Decimal
CPU buffer
memory fixed
cycle area
HG** *2
002EH
*1: For ASCII code, specify device codes with 4 digits. For device codes with 3 digits or less, add an asterisk (*)
(ASCII code: 2AH) or a space (ASCII code: 20H) after the device code.
*2 : When the CR800-Q controller is used, the HG devices cannot be used as SLMP-compatible devices.
• Start device or device number
Specify the start device or device number in decimal.
Specify the subcommand 0032/0082 device number (ASCII code) with 10 bytes (10 digits).
 Response data
The same applies if no extension is specified.
 Communication example
The start I/O number accesses the 03E0H CPU module buffer memory (address: 1).
Show the request data when performing communication with ASCII code.
• When performing data communication in ASCII code
• When performing data communication in binary code
First device No. or
device No.
Device
code
Subcommand
(Request data)
Extension
designation
Device
co
de
Subcommand
(Request data)
First device No.
or device No.
Extension
designation