Mitsubishi Electric CR800 Series - Using Data Link Function

3 Description of functions
3-9
3.2.2. Using data link function
This section explains the operations for starting the sample program given in "4.2.1 Sample program for data link function"
and communicating with a system in which the controller and network personal computer are connected with a one-on-one
cross cable.
Connecting the controller and personal computer.
… Refer to section 3.2.2.1
|
Setting the personal computer network.
… Refer to section 3.2.2.2
|
Setting the controller parameters. … Refer to Chapter 3.2.2.3 (1)
Refer to Chapter 3.2.2.3 (2)
|
Starting the sample program.
… Refer to section 3.2.2.4
|
Communication.
… Refer to section 3.2.2.5
|
Ending
… Refer to section 3.2.3
3.2.2.1. Connect the controller and personal computer.
Connect the controller and personal computer with a cross cable.
Refer to the connection described in section "2.1 Ethernet cable".
3.2.2.2. Setting the personal computer network.
Set one of the following clauses as reference corresponding to the customer's system configuration. (The controller is the
server or the client)
• 2.2.4 Parameter setting example 2-1 (When the data link function is used: When the controller is the server.)
• 2.2.5 Parameter setting example 2-2 (When the data link function is used: When the controller is the client.)