Mitsubishi Electric CR800 Series - 2 Preparation before Use; Connection of Ethernet Cable

2 Preparation before use
2-1
2. Preparation before use
What is done before use is described.
Connection of Ethernet cable
… Refer to 2.1.
↓
Parameter setting
… Refer to 2.2.
2.1. Connection of Ethernet cable
As shown below, connect the Ethernet cable to the connector.
When the hub is used, use the straight cable. Or when the personal computer and controller are connected to each other
one to one, use the cross cable.
<CR800-Q controller>
Robot CPU unit front
PERIPHERAL I/F connect
<CR800-R controller>
Robot CPU unit front
LAN connect
<CR800-D controller>
CR800-D controller front
LAN connect